Next >>

STEP 1 (at meter)

 

Action /
Key Entry

Meter Display
 

Display Description /
User Action

       
   

  1  

 Write your Postage-On-Call account number in the space provided on the worksheet.
 

  2  

Press ADD$ key
To Enter Remote Setting Mode

  ENTER POC PIN#
  ***__

Supervisor Pin Number Requested
 
Note : If the display shows P-20 or P-30, refer to the Troubleshooting section in the POSTAGE-ON-CALL Operator Instructions.
 

  3  

 Enter Supervisor Pin

  P01     POC MODE
  SN              3800000

Meter Serial Number
Record on Worksheet

 

  4  

 Press ENT key

  P02     POC MODE
  DES                1.000

Descending Register
Record on Worksheet
(include all digits displayed)

 

  5  

 Press ENT key

  P03     POC MODE
  ASC              500.000

Ascending Register
Record on Worksheet
(include all digits displayed)
 

  6  

 Press ENT key

  P04     POC MODE
  ADD$              0.000

Prompt for Reset Amount
Record your Reset Amount on Worksheet
Note : If you have not completed a prior setting procedure, the meter will display the previously selected reset amount at the P04 prompt.
  • Press ENT to go directly to the P06 prompt to enter a setting code.
    or
  • Press CLR to enter a different reset amount.  It must be the same as was requested from the Postage-On-Call Data Center, or the meter will not accept the setting code.
    •  

      7  

    Enter Reset Amount 
    (whole dollars only)

    Press ENT key

      P05     POC MODE
      VERIFY$           0.000

    		Prompt for Reset Amount Verification
     

      8  

    Enter Reset Amount again 
    (whole dollars only)

    Press ENT key

      P06  ENT POC CODE
      -------------------

    		Prompt for Setting Code entry
     
    Note : If the verify amount does not match the reset amount previously entered, the meter display will return to the P04 ADD$ prompt.  Press ENT to accept the new amount displayed or press CLR to enter a new reset amount.

    Next >>